Yngvild Barrow-navmesh

[Mebantiza]

Is it possible to make any improvements to Yngvild barrow near 00031076.  That's the spot where there is a hole\spiral that goes down the lower level. 2 draugr inhabit the area. One on the upper part, one down at bottom. The problem Ive always had here, is followers once aggrod, will not jump down and engage IF, the 1st dragr gets knocked to bottom with the 2nd one, OR once the first one is dead, the follower simply cant jump down and engage the lower one. All the follower does, is remain stuck up top. If you smack the follower, they actually run back towards the direction of the entrance until they lose aggro. Otherwise, they just stand up top in combat and wont move down to engage.

 

There are of course workarounds for this impossible behavior

 

You can paralyze the follower and push them down below to force the issue

Or, you can fus-do-rah them to achieve the same thing,

 

But if you have neither spell, its a lot harder.

 

Once both are dead, followers will follow you below as they should. But its a different matter with one or both alive and sitting at the very bottom and the follower is aggrod up top. I reported a similar problem with the mesh in wolfskull cave a while back and it led to substantial improvements there. It is a similar situation in here, but its  problematic only when in combat.

 

[Leonardo]

Do you use AFT?

 

If not then I strongly suggest that you install AFT since AFT has a spell that will bring any follower near you sort of a PlaceAtMe console command.